The last four numbers express, in pixels, the position of the left, top, right, and bottom edges of the remote session window. Ignore the initial ":s:0,1," and focus on the last four comma-delimited numbers. The most important parameters are the numbers after winposstr. rdp file contents will look like this: screen mode id:i:2 There is some detailed additional in depth analysis of the interrelationship between these settings in this article on the Ohman Automation Corp website. The Remote Desktop Blog has an article on this that you can find here. If you are opting for a Windowed mode then the Window size you choose must be larger than the remote desktop size by some number of pixels that will vary depending on the dpi of your desktop but traditionally this would have been about 6 extra pixels in width and 27 or so in height (for the title bar). Obviously if this is larger than the window size you choose you will have scroll bars to deal with and if it's smaller then you will have unused space around the desktop. Where x and y are the dimensions of the desktop you want in pixels. The remote desktop size is set by the following two rdp file settings. The TS client will choose the best monitor in the latter mode depending on which physical monitor has the best overlap with the t,l,r,b requirements in the winposstr setting. Set x to 1 for Window mode and 2 for the RDP "Full Screen" mode. The Screen Mode option tells the TS Client to open in either Windowed or Full Screen mode screen mode id:i:x Opens up a 800圆00 window 100 pixels in from the left edge of your leftmost monitor and 100 pixels down from the upper edge. The l,t coordinates are relative to the standard Windows origin where (0,0) is the upper left of the virtual desktop and the r,b values are absolute width and height so: winposstr:s:0,1,100,100,800,600 M = mode ( 1 = use coords for window position, 3 = open as a maximized window ) The key settings are winposstr:s:0,m,l,t,r,b You can also independently set the remote desktop width and height within the window area you define. There are screen position and mode options in the RDP file which control this by setting the RDP Client window position and size but there aren't explicit options that specify which monitor, you will have to work with the settings and choose ones that deliver the results you want on your combination of monitors.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |